RFIM-20B
- Manufacturer part no.
- EAN
Ordering
- Order unit
- piece
Description
Wireless contact converter can transform your existing button / switch to the wireless one DESCRIPTION It can be used to transfer an information about the contact status (close) - e.g. detector, button, technology, output. 2 types of switchers: RFIM-20B - 2 inputs, intended for switching with button or impulse, and also for permanent contact = switch. RFIM-40B - 4 inputs, intended for switching with button or impulse. 2 or 4 inputs enable your to control 2 units independently of each other. After pressing the button, the set commands are transmitted (ON/OFF, dimming, scheduled OFF/ON, roll up / down). The possibility to set scenes - by one touch you can control more iNELS RF Control units. TECHNICAL PARAMETERS Battery-powered (3V/CR2477 or 2x3V/CR2477 - included in the package), battery life is up to 5 years. Range up to 200 m (free open space), in the case of insufficient signal between controller and unit, please use the signal repeater - RFRP-20. Communication frequency 868 MHz with two-ways protocol iNELS RF Control. BOX design intended to be mounted directly into an installation box/under the existing button/switch
Technical data
ETIM class: Binary input for bus system (EC000688)
Communication
- Bus system KNX
- No
- Bus system KNX-RF (Radio Frequency)
- No
- Bus system radio frequency
- No
- Bus system LON
- No
- Bus system Powernet
- No
- Other bus systems
- None
Options
- Radio frequency bidirectional
- No
- Bus module detachable
- No
Mounting/installation
- Mounting method
- Flush-mounted
Measurements
- Width in number of modular spacings
- 0
- Min. depth of built-in installation box
- UN mm
Connection
- With bus connection
- No
- Number of inputs
- 2
Setting/control
- LED controlling
- Yes
Model/type
- With LED indication
- Yes
Electrical
- Input voltage
- 3, 3 V
- Type of voltage (input voltage)
- UN
Operating conditions
- External signal voltage necessary
- No
Protection
- Degree of protection (IP)
- IP30