PRI-51/8A
- Manufacturer part no.
- EAN
Ordering
- Order unit
- piece
Description
Serves for monitoring of heating in rail-switches, heating cables, consumption of one-phase motors, indicates current flow DESCRIPTION In suitable wiring, it can act as a power cutter for the power reserve and allow you to reduce the size of the main circuit breaker (and thus the amount of payment for this circuit breaker). The design reduces the thermal stress of the product compared to the conventional solution with the built-in shunt, increases the current range up to 20A and galvanically separates the measured circuit. Supply from monitored voltage. In conjunction with the supplied current transformers, the basic current ranges can be expanded up to 600A, increasing the range of use. Preferred (priority) relay – two appliances (boiler and floor heating) operating on one phase, but never run together – prevention against current overload and circuit breaker tripping. Enables to save your main breaker expenses. Supply is galvanically separated from measured current. TECHNICAL PARAMETERS Power voltage AC 24 – 240 V, DC 24 V Output contact: 1x changeover 8 A/AC1 (AgNi, 2500 VA) Slight setting (by potentiometer ) of tripping current, choice from 6 ranges: PRI-51/0.5A: AC 0.05 – 0.5 A PRI-51/1A: AC 0.1 – 1 A PRI-51/2A: AC 0.2 – 2 A PRI-51/5A: AC 0.5 – 5 A PRI-51/8A: AC 0.8 – 8 A PRI-51/16A: AC 1.6 – 16 A Current flowing through monitored wire must not exceed 100 A. 1-MODULE, DIN rail mounting.
Technical data
ETIM class: Current monitoring relay (EC001440)
Connection
- Type of electric connection
- Clip connection
- Number of contacts as normally closed contact
- 1
- Number of contacts as normally open contact
- 1
- Number of contacts as change-over contact
- 1
Model/type
- With detachable clamps
- No
Electrical
- Current measuring range
- 0.8, 8 A
- Rated control supply voltage AC 50 Hz
- 24, 240
- Rated control supply voltage AC 60 Hz
- 24, 240
- Single-phase under current possible
- Yes
- Rated control supply voltage DC
- 24, 24
- Three-phase under current possible
- No
- Voltage type for actuating
- AC/DC
- Single-phase overcurrent possible
- Yes
- Three-phase overcurrent possible
- No
Options
- Single-phase hysteresis possible
- Yes
- Three-phase hysteresis possible
- No
- Contains function DC-voltage under current
- No
- Contains function DC-voltage overcurrent
- No
- Function DC-current hysteresis
- No
- External current transformer
- UN
Setting/control
- Min. adjustable delay-on energization time
- 0.5 s
- Min. adjustable off-delay time
- 0.5 s
Operating conditions
- Max. permitted delay-on energization time
- 10 s
- Max. permitted off-delay time
- 10 s
Measurements
- Width
- 17.6 mm
- Height
- 90 mm
- Depth
- 64 mm